Gentex SPH-4B, Сборка

Страница: 11 / 16

ANVIS ATTACHMENT
Before an ANVIS NVG is installed on the SPH-4B helmet, the ANVIS mount must
be modified, and a cable clip must be attached to the helmet. The ANVIS
attachment kit contains installation instructions, four screws for the rear of the
mount, a cable clip with an attaching screw, pile fastener for attachment of the
ANVIS battery pack to the helmet, and moleskin lens guards for visor protection.
Perform the modification as follows:
1. Remove the outer visor lock from the dual visor assembly by removing the
center screw, lock, and washer. Set aside for reinstallation.
2. Remove the top two screws from the dual visor assembly, lift the housing
from the tracks, and reinstall the screws beneath the housing and into the
tracks. Repeat the procedure for the bottom visor assembly screws, and
remove the housing from the helmet. This will ensure that the visor assembly
remains intact during the ANVIS mount installation.
3. Remove and discard the four screws from the rear of the ANVIS mount.
Place the mount on the ANVIS mounting platform at the center of the dual
visor housing, and align mount the holes with the four holes in the platform.
Secure mount to housing by inserting four 3/16" pan-head screws (supplied)
through the inside of the housing and into mount. Fasten the screws
securely, but do not tighten them too much.
4. Attach moleskin lens guards to the inside of the visor housing around the
ANVIS mounting platform as shown in Figure 8.
5. Reattach the visor housing to
the helmet using the four
screws removed in from the
housing in Step 2.
6. Position the cable clip on
right side (as worn) of the
visor housing, and secure
using the 5/16" screw
supplied. Insert the screw
through the clip and into the
insert on the bottom of
right-side of the upper visor
track. Feed the cable through
the clip, and tighten the
screw securely, but do not
tighten it too much.
7. Install the outer visor lock
by reinstalling the screw,
lock, and washer removed
in Step 1.
8. Attach the pressure-sensitive
pile fastener to the center
rear of the helmet as shown
in Figure 8.
9
MOLESKIN
(ON INSIDE)
DUAL
VISOR
HOUSING
CABLE
CLIP
ANVIS
MOUNTING
PLATFORM
OUTER
VISOR LOCK
Figure 8. Dual Visor Assembly
PILE FASTENERS