•
►
Release button 6 on remote control 5.
•
►
Firmly press, and release the programmed button 2, 3, or 4 of the integrated garage door
e the device. If the device activates, programming is
complete. If the device does not activate, continue with "Synchronizing the Rolling Code."
Your vehicle must be within range of the garage or gate opener drive. Make sure that neither
cts are present within the sweep of the door or gate. A ladder
and/or second person may simplify the following steps.
•
►
Turn the SmartKey to position 2 in the ignition lock.
•
►
At the garage door opener receiver (motor-head unit) in the garage, locate the “Learn” or
e motor-head unit (see the Garage
Door Opener manual to identify the “Learn Button”).
•
►
Press the previously programmed transmitter button 2, 3, or 4 of the integrated garage door
the device activates, programming is
complete.
Canadian radio frequency laws require a "break" (or interruption) of the transmission signals
nals may not therefore last long enough for the
integrated garage door opener to recognize the signal during programming. Comparable with
follows:
r a
•
►
Press button 6 of the garage door remote control 5 for two seconds, then release it for two
opener up to three separate times to activat
Synchronizing the rolling code
your vehicle nor any persons/obje
Observe the safety notes when performing the rolling code synchronization.
“Smart” Button. This can usually be found directly on th
There are typically 30 seconds to complete the next step.
opener up to three separate times to activate the device. If
Notes on programming the remote control
after broadcasting for a few seconds. These sig
Canadian law, some U.S. garage door openers also feature a “break.”
If you live in Canada or have difficulties programming the garage door opener (regardless of
where you live) when using the programming steps above, proceed as
•
►
Press and hold one of transmitter buttons 2 to 4 of the integrated garage door opener. Afte
short time, indicator lamp 1 lights up yellow.
•
►
Release the button. Indicator lamp 1 flashed yellow.
seconds.
•
►
Repeat this sequence on button 6 of remote control 5 until indicator lamp 1 lights up green.
HomeLink
and
the
HomeLink
house
are
registered
trademarks
of
Gentex
Corporation.
