VEGA BUS
ENGLISH
Guide for the installer
Pagina 5
TECHNICAL SPECIFICATIONS
Power supply
f r o m B U S G - W a y
connection, with two 24V
non-polarised wires
Absorption (mA)
10
Max. range (m)
15
Protection class
IP54
Obstacle detection
time (msec.)
20
Alignment
Automatic
Self-alignment angle
±7° (15m)
±13° (5m)
Operating ambient
temperature
-20 +55
Installation
Wall-mounted
Dimensions
See fig. 1
INSTALLATION
These photocells can only be used with
Genius equipment featuring a BUS G-WAY
technology.
A max. of 16 pairs of photocells can be
connected on each system.
To set the operating mode of the photocells,
refer to the instructions of the control unit.
The receiver and the transmitter must be
aligned.
Two installation types are possible:
With recessed tube, Fig. 2.
With external tube or external sheath, fig. 3.
In both cases operate as follows:
•
Prepare the electrical connections.
•
Secure the housings by means of suitable
fastening systems.
•
The connection wires must be routed through
the supplied cable gland (fig. 2 and 3 ref.
a
).
CONNECTIONS
The BUS connection is formed by two
non-polarised conductors
•
Connect the photocells as shown in Fig. 4
•
For the connection to the control board refer to
the specific instructions.
START-UP
•
The dip-switch DS1, which is located on the
boards, determines the behaviour and the
address of the photocell pairs.
•
For a correct set-up of the dip-switches, refer to
the instructions of the control unit.
•
Each pair of photocells must have the same
setting.
•
Power up the system and check the behaviour of
DL2 LED according to the table below:
Status
Description
Steady light
Correct operations
Flashing
Incorrect BUS connection
OFF
Does not operate/disconnected
•
Check LED DL1 for the correct alignment of the
photocells:
Status
Description
ON
Correct alignment
OFF
Incorrect alignment
DECLARATION OF CONFORMITY
Manufacturer:
GENIUS S.p.A. con Socio Unico
Address:
Via Padre Elzi, 32 - 24050 -
Grassobbio- Bergamo - ITALY
Declares that:
The optoelectronic protection
device mod.
VEGA-BUS
•
complies with the essential safety requirements
of the following EEC directives:
•
2006/95/EC Low Voltage Directive.
•
2004/108/EC Electromagnetic Compatibility
Directive
Additional note:
This product underwent tests in a typical
homogeneous configuration (all products
manufactured by GENIUS S.p.A.)
Grassobbio, 04 July 2011
Managing Director
Enrico Nardi
