PULL BAR END CAP
Insert the
H-Pull Bar End Cap
into the end of the
Pull Bar
and tap in place using a
soft mallet.
F
G
E
A
Make sure that the long tooth on the
F-Bushing
and
E-Brake
line up with one of
the slots inside the
Screen Tube.
Both the
E-Brake
and the
F-Bushing
must be fully
inserted into the
Screen Tube
before the
G-End Cap
can be properly seated.
END CAP ASSEMBLY
CONT.
The
E-Brake, F-Bushing
and
G-Cassette End Cap
come pre-assembled.
Slip the
F-Bushing
down the coiled spring to the
E-Brake.
On the open end of the
A-Screen Cassette
, insert the
E-Brake
with
F-Bushing
into the center of the
Screen
Tube
, aligning the long tooth on both as noted above. Next, match up the large pin
on the top of the
G-End Cap
to the corresponding hole at the top of the
A-Screen
Cassette Housing.
Tap evenly with a soft mallet until the assembly fits snugly.
P A G E 4
C A S C A D E
I N S T A L L A T I O N I N S T R U C T I O N S
SCREEN KITS USING 41mm or 42mm CASSETTE
HANDLE ASSEMBLY
Step 1:
Cut out template and position onto the pull rail at desired location. Use tape
to hold in place.
Step 2:
Drill two 3/16” holes all the way through the pull rail.
Step 3:
Attach the handle using (2) #8-32 x ½” Phillips Pan Head screws.
3.00"
4.50"
5/8"
1.575"
5/8"
FLUSH WITH TOP