Genie Z-34/22IC, Руководство по обслуживанию

Страница: 76 / 185

4 - 4 Z-34/22 IC Part No. 128267
July 2007 Section 4 • Repair Procedures
REV A
21 Bring the machine to top drive speed before
reaching the start line. Begin timing when your
reference point on the machine crosses the
start line.
22 Continue at full speed and note the time when
the machine reference point passes over the
finish line. Refer to Section 2,
Specifications.
Result: The stowed drive speed does not meet
specification. Adjust the
HI RANGE
potentiometer
on the drive joystick clockwise to increase the
speed or counterclockwise to decrease the
stowed drive speed. Continue to perform steps
20 through 22 until the stowed drive speed
meets specification.
Set the raised drive speed:
Note: Select a test area that is firm, level and free
of obstructions.
23 Press down the foot switch and raise the
primary boom approximately 3 feet / 1 m.
24 Choose a point on the machine; i.e., contact
patch of a tire, as a visual reference for use
when crossing the start and finish lines.
25 Bring the machine to top drive speed before
reaching the start line. Begin timing when your
reference point on the machine crosses the
start line.
PLATFORM CONTROLS
26 Continue at full speed and note the time when
the machine reference point passes over the
finish line. Refer to Section 2,
Specifications.
Result: The raised drive speed does not meet
specification. Adjust the
LO RANGE
potentiometer
on the drive joystick clockwise to increase the
speed or counterclockwise to decrease the
raised drive speed. Continue to perform steps
24 through 26 until the raised drive speed
meets specification.
27 Lower the primary boom to the stowed position.
Turn the engine off.
28 Close the platform control box lid and install
the fasteners.