Genie GS-3384, Руководство по обслуживанию и ремонту

Страница: 33 / 193

September 2016 Service and Repair Manual
Scissor Components
Part No. 1272222 GS-84 • GS-90 21
10 Place a rod through the cable tray pivot pin
and twist to remove the pin. Lower the cable
tray down.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
11 Secure both ends of the number 3 inner and
outer arms (index #2 and #11) together with a
strap or other suitable device.
12 Attach a lifting strap from an overhead crane
to the number 3 inner and outer arms (index
#2 and #11) at the steer end of the machine.
Do not apply any lifting pressure.
13 Attach a lifting strap from an overhead crane
to the number 3 inner and outer arms (index
#2 and #11) at the non-steer end of the
machine. Do not apply any lifting pressure.
14 Remove the pin retaining fasteners from both
number 3 pivot pins (index #4) at the
non-steer end of the machine. Do not remove
the pins.
15 Remove the pin retaining fasteners from both
number 3 pivot pins (index #13) at the steer
end of the machine. Do not remove the pins.
16 Use a slide hammer to remove both number
3 pivot pins (index #4) from the non-steer end
of the machine.
17 Use a slide hammer to remove both number
3 pivot pins (index #13) from the steer end of
the machine.
18 Carefully remove the number 3 inner and
outer arms (index #2 and #11) from the
machine.
Crushing hazard. The number
3 inner and outer arms could
become unbalanced and fall
when they are removed from the
machine if not properly
supported by the overhead
crane.
Note: If further disassembly of the scissor arm pair
is required, refer to Repair Procedure,
How to
Disassemble a Scissor Arm Pair.
19 Secure the non-steer end of the number
2 inner and outer arms (index #5 and #6) and
the non-steer end of the number 1 inner and
outer arms (index #8 and #16) together with a
strap or other suitable device.
20 Attach a lifting strap from an overhead crane
to the number 1 outer arm (index #16) at the
non-steer end of the machine. Do not apply
any lifting pressure.
21 Remove the pin retaining fasteners from the
number 1 pivot pins (index #10) at the
non-steer end of the machine.
22 Use a slide hammer to remove both number
1 pivot pins (index #10) from the non-steer
end of the machine.
23 Carefully lift the number 1 outer arm at the
non-steer end approximately 15 inches /
40 cm.
24 Place a 6 x 6 x 32 inch / 15 x 15 x 80 cm long
block across both sides of the chassis under
the barrel end of the lift cylinder.