11
English
motor will quickly overheat and possibly cause motor damage in addition to producing an inferior
workpiece surface.
• Do not sand in on spot too long. The sander can easily remove too much material, producing an
uneven surface. Use long sweeping strokes while sanding, gradually moving to progressively finer
grit abrasive paper until the desired surface finish is achieved.
•. Your sander’s lightweight and comfortable palm grip make it ideal for doing work overhead and on
vertical surfaces,although these positions will affect dust collection efficiency.
• When your ready to change paper or are finished with a job, lift the sander away from the work
surface, press the switch into the "O" (OFF) position, then unplug the sander while changing paper
and/or to prevent inadvertently starting prior to tool storage.
MAINTENANCE
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from
various types of commercial solvents and may be damaged by their use. Use clean cloths to remove
dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact with plastic parts.
Chemicals can damage, weaken or destroy plastic which may result in serious
personal injury.
Electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject
to accelerated wear and possible premature failure because the fiberglass chips and grindings are
highly abrasive to bearings, brushes, commutators, etc. Consequently, we do not recommended using
this tool for extended work on these types of materials. However, if you do work with any of these
materials, it is extremely important to clean the tool using compressed air.
LUBRICATION
This tool is permanently lubricated at the factory and requires no additional lubrication.
