2-
1. Safety Instruction
WARNING
y
Please keep this User Guide for future consultation. If you sell the unit to another user, be
sure that they also receive this instruction booklet.
y
Unpack and check carefully there is no transportation damage before using the unit.
y
Before operating, ensure that the voltage and frequency of power supply match the power
requirements of the unit.
y
It’s important to ground the yellow/green conductor to earth in order to avoid electric
shock.
y
The unit is for indoor use only. Use only in a dry location.
y
The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
y
Disconnect main power before replacement or servicing.
y
Make sure there is no flammable materials close to the unit while operating as it is fire
hazard.
y
Use safety cable when fixes this unit. Don’t handle the unit by taking its head only, but
always by taking its base.
y
Maximum ambient temperature is ta: 40
℃
. Don’t operate it where the temperature is
higher than this.
y
Unit surface temperature may reach up to 85
℃
. Don’t touch the housing bare-hand during
its operation. Turn off the power and allow about 15 minutes for the unit to cool down
before replacing or serving.
y
In the event of serious operating problem, stop using the unit immediately. Never try to
repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or
malfunction. Please contact the nearest authorized technical assistance center. Always
use the same type spare parts.
y
Do not touch any wire during operation as high voltage might be causing electric shock.
Warning
y
To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or
moisture.
y
Do not open the unit within five minutes after switching off.
Please read carefully the instruction, which includes important information
about the installation, usage and maintenance.
3-
y
The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly
damaged.
Caution
There are no user serviceable parts inside the unit. Do not open the housing or attempt
any repairs yourself. In the unlikely event your unit may require service, please contact
your nearest dealer.
Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit
is firmly fixed to avoid vibration and slipping while operating. And make sure that the
structure to which you are attaching the unit is secure and is able to support a weight of 10
times of the unit’s weight. Also always use a safety cable that can hold 12 times of the
weight of the unit when installing the fixture.
The equipment must be fixed by professionals. And it must be fixed at a place where is out
of the touch of people and has no one pass by or under it.
2. Technical Specification
•
The unit is DMX 512 fixture. It features full DMX 512 control. It can be also linked together
in master/slave connection, as many as required and run by built-in program chase
sequences automatically or by sound activation through an internal microphone to create
an intelligent effect.
•
It can be operated by DMX 512 control or can be used as an individual unit without a
controller.
•
Features different preprogrammed chase patterns.
•
Please use a cable when connecting units together.
•
Accurate focusable optics system and ultra smooth stepping motors, Fan cooled.
•
Pan: 540 deg. Tilt: 270 deg.
•
Voltage
：
AC 120V~60Hz/230V~50Hz
•
Power consumption: 55W
•
Dimension: 248x 228 x 330 mm
•
Light Source: 1×20W LED
•
Weight: 5.6 kg
