To display the lowest (minimum) values
of the two parameters shown in
the selected mode, press the
MIN/MAX
button once. The Min values will
appear in their assigned positions, with temperature on the lower readout
and RH, Dew Point or Heat Index on the upper readout.
MIN
will appear
on the bottom line of the LCD to indicate that the readouts are showing
minimum values.
To display the highest (maximum) values
of the two parameters shown
in the selected mode, press the
MIN/MAX
button a second time. Like Min
values, the Max values will appear in their assigned positions on the
primary and secondary readouts.
MAX
will appear on the bottom line of
the LCD to indicate that the readouts are showing maximum values.
To exit Min/Max mode
and resume showing real-time values, press and
hold the
MIN/MAX
button a third time.
To clear the Min/Max memory
, press the
RESET
button. The instrument
will confirm the erasure by briefly showing all LCD indications at the
same time, followed by a single beep.
DISABLING AUTO POWER OFF
To conserve battery charge, the SAM800HI/SAM800IND monitor
automatically powers off after any 20-minute period of front-panel
inactivity.
To disable this Auto Power Off function
, power the unit off and then
power it back on in the following special way: Press and hold the
HOLD
button before pressing the
ON/OFF
button. Doing so will cause a large,
lower-case “n” to appear on the LCD. Two seconds later, the
n
will
disappear and the instrument will power on normally—but with the APO
function disabled. There is no display indication of APO status (whether
the function is enabled or disabled).
SPECIFICATIONS
• Temperature Measurement Range: 32° to 122°F (0° to 50°C)
• Temperature Measurement Accuracy: ±1.8°F (±1°C)
• Relative Humidity Measurement Range: 0 to 100%
• RH Measurement Accuracy: ±3% of reading from 10 to 90%RH; ±4% of
reading elsewhere
• Dew Point Measurement Range/Accuracy: 32° to 140°F (0° to 60°C)/ ±3%
• Heat Index Range/Accuracy: 70° to 115°F (21° to 45°C)/ ±3%
6
