Water Pipe
Figure 3
6
the other scanning bars might appear which
will actually be the “PEAK”.
• It is recommended to perform metal/voltage
detection to make sure the detected wood stud
or batten is not a metal pipe or energized
cable. Please note that some small securing
screws or nails may be detected.
METAL DETECTION
Check that there is no metal in the immediate
vicinity. Turn on the instrument by pressing the
Power Function selector button once which is
located on the left side of main body of the unit.
The icon will appear on the LCD screen.
At this moment, auto calibration for metal
detection will start by displaying the scanning
bars from the bottom of the scanning indicator.
This procedure will complete when the scanning
Indicator shows a full scale of reading and then
quickly disappears. At the same time, the scan
symbol will display on the LCD screen with a
short “beep” tone. The instrument is ready for
metal scanning now.
Metal Scanning
Hold the instrument horizontally with the sensor
head pointing towards the wall (see Figure 3) and
sweep systematically over the required area. If a
MSV350D-FINAL- 033009:Layout 1 3/30/09 9:36 AM Page 6