Receiving and Displaying Data from a Second GT320 or a GT310
To configure your GT320 to receive display measurements and
indications from another GT320 or a GT310 wireless multimeter, use
the
Power/Tx/Rx/Ax
button.
When the meter is powered on, the default setting is no communication.
To enable transmission, briefly
press the Power/Tx/Rx/Ax button
once
. The term
T0
will appear and
the display will look like this:
To enable reception, briefly press
the Power/Tx/Rx/Ax button a
second time
. The term
T0
will be replaced by the term
R0
. In “receive
only” mode, your GT320 will not display any of its own measurements;
it will only display measurements from a second wireless multimeter.
Immediately after you enable
receive mode, your GT320 will
operate in “standby receive mode”
until you synchronize its receiving
channel with the transmitting
channel of the other meter. Before
you synchronize the two meters,
the display will look like this:
After you synchronize the two
multimeters, the new display will
duplicate the data shown on the
second meter and look like this:
To match the receiving channel of your GT320 to the transmitting
channel of the second multimeter, press and hold the Hold/CH
button
, and then press it briefly to cause the lower readout to show
R = 0
. Quickly (within 10 seconds), press the
Select/0-9
button as
many times as needed until the receiving channel number of your
GT320 matches the transmitting channel number of the second
multimeter.
To enable transmission and reception, briefly press the
Power/Tx/Rx/Ax button a third time
. This will cause both terms
(Tx and Rx) to appear at the right of the display. The upper reading will
18
