UNPACKING & HANDLING
Carefully unpack and remove the scroll saw and its
components from the box and check for damaged
or missing items as per the list of contents below.
NOTE: Please report any damaged or missing items to
your General International distributor immediately.
INSTALLATION & ASSEMBLY
For your convenience this scroll saw is shipped from the factory partially assembled and requires only minimal
assembly and set-up before being put into service.
BEFORE STARTING THE ASSEMBLY, MAKE SURE
THAT THE SWITCH IS IN THE “OFF” POSITION
AND THAT THE POWER CORD IS UNPLUGGED.
DO NOT PLUG IN OR TURN ON THE SCROLL
SAW UNTIL YOU HAVE COMPLETED THE ASSEM-
BLY AND INSTALLATION STEPS DESCRIBED IN
THIS SECTION OF THE MANUAL.
NOTE: Unscrew the 4 shipping bolts and remove the saw
from the protective plywood shipping base.
LIST OF CONTENTS
QTY
A
- SCROLL SAW..............................................................1
B
- POWER CORD ...........................................................1
C
- HEX NUT .....................................................................8
D
- LEVELING FOOT .........................................................4
E
- 3 MM ALLEN KEY .......................................................1
F
- BLADE.........................................................................1
A
C
E
F
B
D
Plug the female end of the power cord into the socket
at the rear of the saw as shown.
ATTACHING THE POWER CORD
HANDLING
Never lift the saw by the upper arm assembly as this will
result in damage to the drivetrain.
Rather lift the saw by the front of the table and by the
motor.
9
(EX-21CE-
shown)
