TABLE INSERT RINGS
The router extension wing (Model #50-195) comes with 2 remov-
able insert rings allowing the opening on the extension wing to
be changed to suit the most common sizes of router bits.
The supplied rings come in two sizes: 1 1/8” (29 mm), 2 3/8”
(60 mm), allowing for three different table opening sizes.
The smallest opening is 1 1/8” (29 mm), the largest opening is
2 3/8” (60 mm) and with no insert ring installed the opening in the
wing measures 3 7/8” (98.5 mm).
Fig. 12
ASSEMBLING AND INSTALLING THE ROUTER FENCE (50-295)
Fig. 13
Fig. 14
Fig. 15
Fig. 16
1.
Secure the router fence to the table at each end
by threading a washer and a handle into the
holes located closest to the edge of the table.
2.
Remove one hex nut from each of the hold-down
support arms.
Note: You may have to loosen the horizontal fence
adjustment knobs and slide the fences apart to give
you enough clearance to easily complete the fol-
lowing steps (See section Fence Adjustments on
page 8 for instructions on moving the fence).
3.
Fit the threaded ends of the hold-down support
arms through the holes on the dust hood secure
the support arms in place using the hex nut,
,
removed in step 2.
4.
Slide a hold-down bracket into each of the hold-
down support arms. Slide a hold-down into the
hold-down bracket (make sure the legs of the
hold-downs are pointing against the rotation of
the router bit, see section “Using the workpiece
hold-downs” on page 8) and tighten using the
lock knob on the hold-down bracket.
Precise placement and postioning, of the hold-
down brackets or the hold-downs can be adjust-
ed later and will vary depending on the height
and width of the workpiece.
7
1 1/8” (29 mm)
2 3/8” (60 mm)