General 10-110, Руководство по эксплуатации

Страница: 5 / 18

Plug the dust collector into a proper receptacle. Your power tools should be connected to a dedicated electrical
circuit of not less than #14 wire and should be protected with a 15 amp time lag fuse. If an extension cord is needed
use only 3 wire cords with 3-prong grounded type plugs and 3-pole receptacles. Consult the chart below for details
on selecting an extension cord.
GROUNDING
This dust collector must be grounded to protect the operator from electrical
shock. It has a 3-conductor cord and 3-prong grounded plug to fit a ground-
ed-type receptacle . Do not attempt to modify the plug or remove the 3rd
prong (grounding pin) from the plug to make it fit into an old 2 hole wall sock-
et or extension cord. If an adaptor is used it must be attached to the metal
screw of the receptacle .
Note: The use of an adaptor plug is illegal in some areas. Check your local
codes. If you have any doubts or if the supplied plug does not correspond
to your electrical outlet, consult a qualified electrician before proceeding.
TABLE - MINIMUM GAUGE FOR CORD
VOLTS
110 V
MORE
THAN
18
18
16
14
220 V
AMPERE
RATING
NOT
MORE
THAN
0
6
10
12
6
10
12
16
16
16
16
12 16
14
14
-
14
12
12
-
25 ft.
50 ft. 50 ft.
100 ft.
100 ft.
200 ft. 150 ft.
300 ft.
TOTAL LENGTH OF CORD IN FEET
AWG
BEFORE CONNECTING THE DUST COLLECTOR TO A POWER SOURCE, MAKE SURE THAT THE ELECTRICAL CURRENT
IS OF THE SAME TYPE AS THAT STAMPED ON THE MOTOR NAMEPLATE. ALL ELECTRICAL CONNECTIONS SHOULD
HAVE A PROPER CONTACT. NEVER CONNECT THE MACHINE TO A POWER SOURCE OF GREATER OR LOWER VOL-
TAGE THAN NEEDED. FAILURE TO COMPLY COULD RESULT IN SERIOUS INJURY TO THE USER AND/OR DAMAGE TO
THE MACHINE. IF IN DOUBT, CONTACT A QUALIFIED ELECTRICIAN BEFORE CONNECTING TO THE POWER SOURCE.
5
ELECTRICAL REQUIREMENTS
BEFORE CONNECTING THE MACHINE TO THE POWER SOURCE, VERIFY THAT THE VOLTAGE OF YOUR POWER SUPPLY CORRE-
SPONDS WITH THE VOLTAGE SPECIFIED ON THE MOTOR I.D. NAMEPLATE. A POWER SOURCE WITH GREATER VOLTAGE THAN
NEEDED CAN RESULT IN SERIOUS INJURY TO THE USER AS WELL AS DAMAGE TO THE MACHINE. IF IN DOUBT, CONTACT A
QUALIFIED ELECTRICIAN BEFORE CONNECTING TO THE POWER SOURCE.
THIS TOOL IS FOR INDOOR USE ONLY. DO NOT EXPOSE TO RAIN OR USE IN WET OR DAMP LOCATIONS.