AutoCut PL™
Blade Replacement Instructions
1. Place the tool on a flat surface with screw heads
upwards.
2. Remove all the screws (See diagram)
3. Remove the top half containing the screws from
the lower half. You may need to “wiggle” the parts
to separate them. This will expose the blade.
4. Very carefully remove the old blade using pliers.
Caution: Blade is sharp. Use extreme care.
5. Replace the blade by aligning the hole in the
blade with the peg on the bottom half of the tool
body.
6. Ensure the blade is aligned and seated correctly
in the pocket
7. Replace the top body of the tool by aligning the
pegs and holes.
8. Replace all the screws and tighten.
9. Your tool is ready for more plastic pipe cutting.
Set of 3 Replacement blades: Part # APB.
General Wire Spring Co,
1101 Thompson Avenue
McKees Rocks, PA 15136
412-771-6300
www.drainbrain.com
© General Wire Spring Co. 2020
C-ATCPLOI-042020
Close-up of blade
MAINTENANCE:
For longer tool life, occasionally disassemble the AutoCutPL and clean away dirt, dust or other residue.
REPLACING THE BLADE:
