General International BT8008, Руководство по установке и эксплуатации

Страница: 9 / 40

9
ENGLISH
141212
NOTE:
The use of an adaptor plug is illegal
in some areas, including Canada. Check
your local codes. If you have any doubts
or if the supplied plug does not correspond
to your electrical outlet, consult a qualified
electrician before proceeding.
CIRCUIT CAPACITY
Make sure that the wires in your circuit are
capable of handling the amperage draw from
your machine, as well as any other machines
that could be operating on the same circuit. If
you are unsure, consult a qualified electrician.
If the circuit breaker trips or the fuse blows
regularly, your machine may be operating on
a circuit that is close to its amperage draw
capacity. However, if an unusual amperage
draw does not exist and a power failure still
occurs, contact a qualified technician or our
service department.
EXTENSION CORDS
If you find it necessary to use an extension
cord with your machine, use only 3-wire
extension cords that have 3-prong grounding
plug and a matching 3-pole receptacle that
accepts the tool’s plug. Repair or replace a
damaged extension cord or plug immediately.
Make sure the cord rating is suitable for the
amperage listed on the motor I.D. plate.
An undersized cord will cause a drop in
line voltage resulting in loss of power and
overheating. The accompanying chart shows
the correct size extension cord to be used
based on cord length and motor I.D. plate amp
rating.
Amp
Rating
Total Extension Cord Length
Feet Meters Feet Meters Feet Meters Feet Meters
25 8 50 15 100 30 125 40
3-10 18 ga. 16 ga. 14 ga. 14 ga.
10.1 - 12 16 ga. 16 ga. 14 ga. 14 ga.
12.1 - 16 14 ga. 12 ga. Not Recommended
Use only UL or CSA approved extension cords
If in doubt, use the next heavier gauge. The
smaller the number, the heavier the gauge.