General International 25-650ABC M1, Руководство по установке и эксплуатации

Страница: 16 / 24

16
To lock the spindle:
1. Thread the spindle lock/index pin into one of the threaded holes around the spindle, A .
2. Rotate the flywheel B slowly by hand until the pin finds the groove and bottoms out in the indexing hole.
3. Complete the desired cut, groove or other operation on the spindle.
4. If further grooves are required, loosen the pin again and slowly turn the spindle until the desired position is loca-
ted. Repeat the above steps.
Note: There are 36 evenly spaced holes in the headstock spindle allowing for indexing at 10° increments (360°/36 posi-
tions = 10°)
C
, allowing for a wide variety of symmetrical decorative grooves or patterned cuts.
A
B
PERIODIC MAINTENANCE
•
Keep the unit clean and free of dust by wiping with a cloth or vacuuming off any woodchips or dust after
each use.
•
All bearings are sealed and permanently lubricated and no further lubrication is required.
•
Regular applications of a surface protectant/lubricant will help prevent rust and keep the tool rest, head, and
tailstock sliding smooth on the bedway.
•
Periodically inspect the power cord and plug for damage. Replace the power cord and the plug at the first
signs of visible damage.