ASSEMBLY INSTRUCTIONS (15-825)
For your own safety, never connect the plug to power source outlet until all assembly and adjustment steps are
completed, and you have read and understood the safety and operating instructions.
INSTALLING THE TOOL REST HANDLES
The grinder is supplied with two tool rest.
1.
Attach the tool rest handle (A) to the support using two 12 mm bolts
(B) through two big flat washers for 12 mm bolt (C).
2.
Repeat with the other tool rest handle.
INSTALLING THE EYE SHIELDS
1.
To install the eye shields (A) to spark guard, refer to model 15-625 on
page 8 - eye shields installation.
2.
Repeat for the other eye shield.
A
C
B
K
J
I
H
INSTALLING THE SPARK GUARDS
1.
Install the spark guard (G) to the inside surface of
the wheel cover (H) and put the bracket (I) between those two parts and
tighten a little using a flat washer for 10 mm hex screw (J) and a 10 mm hex screw (K).
2.
Adjust the spark guards to the right angle and until they are 1/16” from the grinding wheels. Firmly tighten the
hex head bolt.
3.
Repeat for the other spark guard.
ASSEMBLING THE TOOL REST
1.
Once the tool rest handle is installed, use the knob (D) to fix the tool
rest plater (E) to the handle (F).
2.
Adjust the tool rests until they are 1/16” from the grinding wheel. Firmly
tighten the hex head bolt holding the support.
3.
Repeat for the other tool rest.
D
E
F
SECURING THE GRINDER TO A WORK SURFACE
Note: To avoid tipping over or sliding during operations,
the grinder should be secured to the work surface or
optional stand.
1.
The base of the grinder has 4 mounting holes allo-
wing the user to permanently mount the grinder to a
workbench or stand.
2.
Place the grinder on the work surface, mark the holes
on the work surface and drill 3/8” holes. Use appro-
priate length bolts, washers and nuts to secure to
secure the grinder to the bench.
3.
If the workbench moves or shakes during operation,
the workbench must be fastened to the floor.
4.
The grinder is designed for use on horizontal surfaces
only. Motor damage may result when mounted on a
non-horizontal surface.
1. Bench grinder
2. Hex head bolt
3. Rubber washer
4. Flat washer
5. Workbench or stand
6. Flat washer
7. Lock washer
8. Hex nut
9. Jamb nut
9
G
A
