INSTALL THE CONTROL BOX
3. Tighten the bolts to secure the control box in place,
with a 10 mm open end wrench.
Do not plug in the power cord yet.
CONNECTING TO A DUST COLLECTOR
Do not operate this sander without an adequate dust collection system properly installed and running. Operating
this sander without adequate dust collection can lead to equipment malfunction or dangerous situations for the
operator or other individuals in the workshop.
OFF
ON
The 24" horizontal drum sander is equipped with two 4”
diameter dust outlets,
, on top of the machine, allow-
ing for the connection to a dust collector
(not included)
.
If you do not already own a dust collection system consider contacting your General® International distributor for
information on our complete line of dust collection systems and accessories or visit our Web Site at: www.general.ca.
Be sure to use appropriate sized hose and fittings
(not
included)
and check that all connections are sealed
tightly to help minimize airborne dust.
8
Note: Recommended dust collection CFM requirements for this sander is 1500 CFM.
1.
Loosen, but do not remove, the 2 hex bolts,
, ins-
talled on the top right hand corner of the machine.
2. Slide the control box onto the heads of the bolts.
