General DataComm PacketMate 1000, Руководство пользователя

Страница: 13 / 20

Note
If you cannot determine whether both devices are on the same circuit, verify that the potential
difference between the grounding circuits of the respective power outlets is no more than 0.25V rms.
To connect the unit to power, perform the following steps:
The PacketMate 1000 comes with a switching power supply which converts the AC supply to a 5
VDC supply. 1.
Attach the male DC plug into the router's female DC power connector located on the rear panel of the
router. 2.
Attach female section of the power cord supplied with the unit into the male outlet on the switching
power supply. 3.
Attach the male section of the power cord supplied with the unit to a wall receptacle or surge
protector device that supplies the required AC power. 4.
Verify that the front panel power LED illuminates to indicate the PacketMate is supplying power to
the router. 5.
Booting the PacketMate 1000 Router
When you start up the router, it carries out the following functions during the booting process:
Self-diagnostics are performed. The results are displayed to the console port. 1.
A selection dialog is displayed that allows the router to be booted into its standard operating mode,
failsafe, or the memory test module. 2.
If no boot option is chosen, Enterprise Linux will load in normal operating mode. 3.
The user configuration is loaded from nonvolatile flash memory. 4.
Logging In for the First Time
Quick Start
The first step in the installation is to Login to the router either by; console using a keyboard and monitor, or
by connecting over your network using telnet or ssh. The router is shipped with a factory default IP address of
10.10.199.199 with a netmask of 255.0.0.0. The serial port baud is 9600 with bits/parity/stop settings of
8/N/1.
PacketMate 1000 Router are configured using a standard menu-based interface. The first time you log in to
your router, you may want to browse the various menus to familiarize yourself with the menu navigation. The
factory default login is root with no administrator password. Type root at the Login prompt and press Enter.
Press Enter at the Password prompt when accessing the router for the first time.
Important Before connecting this unit to a live network, be sure to set an administrative password.
After logging in, the main menu is displayed (your menu may look slightly different):
ISis-Router main menu
1. Configuration menu
2. Show interface status
001
Installation Procedures 9