General Components WALRUS 5000C, Инструкция по эксплуатации

Страница: 7 / 20

WALRUS 5000C
P a g e | 7
1. Heater
2. P-Clip
3. Air Silencer or End Cap
4. 20mm Combustion Air Intake
5. Exhaust P-Clip
6. Exhaust Silencer
7. 24mm Exhaust with End Cap
8. Exhaust Clamps (*)
Figure above shows the installation of the
air intake and exhaust. Make sure you only use
the appropriate pipes provided and use the clamps
to secure them in position.
The air inlet pipe is used to bring in
combustion supporting air into the furnace of the
heater from outside of the vehicle and in the
opposite direction of travel to ensure that the
air is clean and doesn’t clog up the pipe with
dirt and dust.
(*) Not necessary when the silencer is
built into the exhaust as part of a marine
application for example.
Make sure that the exhaust and any other
parts that become hot during the operation of the
heater are away from anything damaged by a high
heat like wires or plastics.
Also, please ensure that the exhaust does
not exit in such a way that the fumes are re-
circulated by the air inlet pipe or can be
inhaled by anyone.
The mounting bracket is supplied in the
installation kit, along with a 100mm M6 hex bolt, used
to secure the heater in place to the bracket using one
of the two M6 taps, located near the center of the
bracket.