Generac Power Systems SD050, Руководство пользователя

Страница: 17 / 112

15
6. Add the recommended oil until it just starts to flow from the
oil level check plug opening. See the following information for
the correct quantity of gear oil and Lucas additive to add to a
particular gearbox.
7. Finally, install and tighten the oil filler/vent cap and oil level
check plug.
8. Re-install negative battery cable and panel fuse. Start unit and
check for leaks.
Gear oil should be 80W-90. Lucas Heavy Duty Oil Stabilizer should
be added (PN 0F6147B).
Fluid Quantity:
• 390 Gearbox - Approximately 32oz total. 26oz gear oil & 6oz
Lucas Heavy Duty Oil Stabilizer.
• 520 gearbox - Approximately 55oz total. 44oz gear oil & 11oz
Lucas Heavy Duty Oil Stabilizer.
• 520 gearbox (D12.0L 375kW) - approximately 85oz total. 68oz
gear oil & 17oz Lucas Heavy Duty Oil Stabilizer.
Figure 4.1 – Gearbox Oil Servicing Points
INSPECT EXHAUST SYSTEM
Every three months (or 30 hours), an authorized operator should
inspect the entire exhaust system. Abnormal noise levels heard
during each operational test may indicate a defective exhaust pipe
or muffler. Any defective or leaking component should be repaired
or replaced immediately by an Authorized Service Technician.
INSPECT/TEST FUEL SUPPLY SYSTEM
Every three months (or 30 hours), an authorized operator should
inspect and test the fuel supply system, as well as all fuel system
connections. All connections must be tight and in good condition.
A loose fuel system line (diesel units) may show no signs of leak-
age, but may draw air into the system causing rough operation and
starting difficulties. Any defective or leaking component should
be repaired or replaced immediately by an Authorized Service
Technician.
MAINTENANCE AND REPAIR PARTS
All recommended service maintenance or repairs should be com-
pleted by an authorized service technician to maintain the warranty
status of a unit.
Maintenance