Generac Power Systems PowerMate 1020, Руководство пользователя

Страница: 15 / 20

Owner’s Manual for Water Pump 13
Storage
Refer to the following list to prepare
equipment for storage.
• DO NOT place a storage cover on a hot
water pump. Allow equipment to cool to
room temperature before storage.
• DO NOT store fuel from one season to
another unless properly treated.
• Replace fuel container if rust is present.
Rust in fuel will cause fuel system
problems.
• Cover equipment with a suitable protective,
moisture resistant cover.
• Store equipment in a clean and dry area.
• Always store water pump and fuel away
from heat and ignition sources.
Prepare Fuel System for Storage
Fuel stored over 30 days can go bad and
damage fuel system components. Keep fuel
fresh, use fuel stabilizer.
If fuel stabilizer is added to fuel system,
prepare and run engine for long term storage.
Run engine for 10-15 minutes to circulate
stabilizer throughout fuel system. Adequately
prepared fuel can be stored up to 24 months.
NOTE: If fuel has not been treated with fuel
stabilizer, it must be drained into an
approved container. Run engine until it
stops from lack of fuel. Use of fuel
stabilizer in fuel storage container is
recommended to keep fuel fresh.
1. Change engine oil.
2. Remove spark plug.
3. Pour a tablespoon (5-10cc) of clean
engine oil or spray a suitable fogging
agent into cylinder.
4. Pull starter recoil several times to
distribute oil in cylinder.
5. Install spark plug.
6. Pull recoil slowly until resistance is felt.
This will close valves so moisture cannot
enter engine cylinder. Gently release
recoil.
Change Oil
Change engine oil before storage. See
Change Engine Oil .
Prepare Water Pump for Storage
Protect equipment from freezing
temperatures. Failure to do so will
permanently damage pump and render
equipment inoperable. Freeze damage is not
covered under warranty.
Protect equipment from freezing temperatures
as follows:
1. Shut engine off by turning engine start
switch to OFF.
2. Disconnect hoses.
3. Let engine cool.
4. Remove water drain plug and drain
trapped water.
5. Turn fuel valve to OFF.
6. Pull recoil handle approximately six times
to remove remaining liquid from pump.
7. Winterize engine per manufacturer
specifications.
Store equipment in a clean and dry area.
Transporting / Tipping
Do not operate, store or transport the
equipment at an angle greater than 15
degrees.
(000143)
DANGER
Explosion and Fire. Fuel and vapors are extremely
flammable and explosive. Store fuel in a well
ventilated area. Keep fire and spark away. Failure to
do so will result in death or serious injury.
(000109)
WARNING
Risk of Fire. Verify machine has properly cooled
before installing cover and storing machine.
Hot surfaces could result in fire.
(000181)
WARNING
Vision Loss. Eye protection is required to avoid
spray from spark plug hole when cranking engine.
Failure to do so could result in vision loss.