Generac Power Systems Magnum MLT3060K, Руководство пользователя

Страница: 29 / 56

Operation
Owner’s Manual for MLT3060M-K Light Tower 25
Section 3: Operation
Light Tower Setup
Figure 3-1. Set Up Outriggers and Jacks
1. For maximum light coverage, position the unit at
ground level or in a spot higher than the area being
illuminated by the lamps.
NOTE: The mast extends up to 30 ft (9.14 m).
2. See Figure 3-1 . Place the unit on firm ground that
is relatively flat, and then block the wheels (A) to
keep it from moving. This will make it easier to level
the unit.
3. Pull the locking pin (B) on the tongue jack and
rotate the jack 90°. Reinstall the locking pin. Turn
the jack handle clockwise to raise the trailer tongue
off of the towing vehicle.
4. A grounding stud (C) is located on the control box.
For grounding requirements, follow the National
Electrical Code (NEC), state, and local regulations.
5. See Detail E. Pull the locking pin (D) on the
outrigger (E) and pull each outrigger out until the
spring loaded locking pin snaps back into place.
Pull the locking pin on the outrigger jack and rotate
each jack 90° so the jack pad is facing down.
Reinstall the locking pin.
6. Pull the locking pin on the rear jack (F) and rotate
the jack 90°. Reinstall the locking pin. Rotate the
jack handle clockwise to start leveling the trailer
(see Detail G). Adjust all four jacks by rotating their
handles (G) clockwise until they are firmly in
contact with the ground and the trailer is as level as
possible.
7. See Detail H. Before raising the mast, it may be
necessary to adjust the lamps. The lamps may be
adjusted up, down, left or right by simply aiming
them in the desired direction.
DETAIL C
DETAIL D
DETAIL G
DETAIL H
H
J
F
H
F
A
G
E
D
C
B
D
E
003789
(000260a)
High Voltage. Verify area above unit is clear
of overhead wires and obstructions. Contact
with high-voltage power lines will result in
death or serious injury.
DANGER