Generac Power Systems MAC400HC, Руководство пользователя

Страница: 17 / 40

Owner’s Manual for Flameless Heat Cart 13
Operation
Figure 3-2. Start Engine
6. Attach air ducting to aircraft, avoiding sharp bends
and twists in duct.
NOTE: A twisted or bent air duct will cause loss of air
pressure and temperature.
7. See Figure 3-3 . The screen displays “Engine
Warming — Please Wait”.
Figure 3-3. Engine Warming
8. See Figure 3-4 . Press ON to start the heat
sequence. Engine warming is complete and the
heater automatically begins warming when coolant
temperature reaches 140 °F (60 °C). The screen
displays “Heater is warming up—Please wait”.
Figure 3-4. Heater Warming
9. See Figure 3-5 . When the heater is warm, heat
begins blowing from ducts, the amber strobe light
on top of the unit activates, and the screen displays
“Heater On — Press OFF to stop the heater”.
Figure 3-5. Heater On
Adjusting Heater Output
Use the up and down arrows to adjust temperature selec-
tion to desired outlet temperature. The options are 100 °F
(38 °C), 120 °F (49 °C), 140 °F (60 °C), and 160 °F (71
°C). Monitor regularly and adjust as needed.
AUTO Mode
In AUTO mode, output temperature is manually set, as
follows:
• To increase output temperature, press (+) ( Figure
3-6 , item A).
• To decrease output temperature, press (-) ( Figure
3-6 , item B).
Figure 3-6. AUTO Mode
MANUAL Mode
In MANUAL mode, heater output can be set to minimum
fan or maximum fan, as follows:
•
For minimum fan, press MIN FAN ( Figure 3-7 , item
A). Minimum fan produces the highest temperature
at the lowest air flow.
001584
001585
001581
001586
001578
A
B