Home Standby Remote Start Kit
Model No. G0071090
2
Instruction Sheet
Wiring
Two wires need to be added to the wire harness. The harness is plugged into a connector on the underside of the
Evolution controller.
1.
See
—Bottom (underside) of Evolution Controller for Steps 1-3. Unplug the 20-pin connector (J1) and the
16- pin connector (J2) from the control panel underside by carefully releasing the latch on the side of each
connector.
Figure 1 - Bottom (underside) of Evolution Controllers
2.
Evolution 1.0 Controllers
—Use the two white wires (0J0973A) from the kit and insert the wire ends, with
terminals, into the open location 5 of the J1 connector and open location 11 of the J2 connector. The other ends of
both white wires will be connected to the start switch.
3.
Evolution 2.0 Controllers—
Use the two white wires (0J0973A) from the kit and insert the wire ends, with
terminals, into the open location 18 of the J1 connector and open location 10 of the J2 connector. The other ends of
both white wires will be connected to the start switch.
4.
See
. Install the J1 and J2 harness connectors back into the J1 and J2 connectors on the back of the
control panel.
5.
Connect the negative (-) black lead to the battery.
6.
Install the generator front panel.
7.
Install the control panel 7.5 Amp fuse.
8.
Leave the generator in the OFF mode.
Evolution 1.0 Controller
J1-5
J2-11
Evolution 1.0 Installation
Evolution 2.0 Controller
J1-18
J2-10
Evolution 2.0 Installation
