Generac Power Systems DF 2.2, Руководство пользователя

Страница: 14 / 16

10 Owner’s Manual for DF 2.2 Dust Suppression System
Maintenance and Troubleshooting
Inlet Filter Cleaning
1. Figure 4-2 . Remove inlet filter plug (A).
2. Remove filter cartridge.
3. Tap cartridge on a solid surface and blow with com-
pressed air to remove sediment.
4. Install cartridge and replace inlet filter plug.
Figure 4-2. Cleaning Inlet Filter
Nozzle Cleaning
1. Remove nozzles from blower cone with a wrench.
2. Soak nozzles in an antilimestone solution over-
night.
3. Rinse nozzles.
4. Reinstall nozzles.
Figure 4-3. Cleaning Nozzles
General Troubleshooting
This information is intended to be a check or verification for simple causes that can be located and fixed. It does not
cover all types of problems. See the engine operator’s manual for additional troubleshooting information.
Procedures
that require in-depth knowledge or skills should be performed by an ASD.
A
A
Problem
Possible Cause Solution
Fan Doesn’t work Plug not correctly connected Verify plug is seated fully in socket.
Uneven water jet Dirty or clogged nozzles Clean nozzles. See
Nozzle Cleaning .