Generac Power Systems 7kW Air-cooled, Руководство пользователя

Страница: 9 / 32

7
\2. Remove the two side panels of the enclosure by lifting the
panels straight up until they are clear.
3. Carefully place the roof and side panels to one side.
4. Locate the fuel throttle assembly mounted to the engine
intake.
5. To change the fuel selection, remove the hose clamp and hose
from the throttle assembly.
6. Remove the Natural Gas (Larger ID) fuel jet from the fuel
inlet.
7. Obtain the fuel jet for Propane (Smaller ID that has been sup-
plied loose with the owners manual).
8. Verify that the O-ring, supplied loose with the owners manual
is installed, into the groove of the fuel jet.
9. Insert the Propane fuel jet into the end of the fuel inlet.
10. Reinstall the hose and clamp onto the fuel inlet and secure.
11. Verify the hose has not been kinked in any way.
Throttle
Assembly
Fuel Jet
Fuel Inlet
O-Ring (installed)
Hose Clamp
Regulator
Hose
12. The generator is now ready to run on LP Vapor fuel.
1.11 LOCATION
n
The engine exhaust fumes contain carbon
monoxide, which can be DEADLY. This dan-
gerous gas, if breathed in sufficient con-
centrations, can cause unconsciousness or
even death. This generator must be installed
properly, in strict compliance with applicable
codes and standards. Following installation,
do nothing that might render the system
unsafe or in noncompliance with such codes
and standards.
Operate the generator outdoors ONLY.
• Keep exhaust gases from entering a confined
area through windows, doors, ventilation, crawl
spaces or other openings (Figure 1.9).
• It is highly recommended that carbon monox-
ide detector(s) be installed indoors according
to the manufacturer's instructions/recommen-
dations.
• The generator must be mounted safely per
applicable codes and the manufacturer's speci-
fications. Do NOT alter or add to the exhaust
system, or do anything that might render the
exhaust system unsafe or in noncompliance
with applicable codes and standards.
General Information
Remove Clamp
and Hose