Generac Power Systems 1195-0, Руководство пользователя

Страница: 5 / 20

H i g h P r e s s u r e W a s h e r
5
Read entire Owner’s manual before you attempt to
assemble or operate your new pressure washer.
Your new pressure washer has been assembled at
the factory with exception of those parts left unassem-
bled for shipping purposes.
REMOVE PRESSURE
WASHER FROM CARTON
• Remove parts box included with pressure washer.
• Slice two corners at guide handle end of carton
from top to bottom so the panel can be folded down
flat, then remove all packing material.
• Roll pressure washer out of carton.
CARTON CONTENTS
Items in the carton include:
• Main Unit
• High Pressure Hose
• Parts Box (which includes the following):
• Wireform
• Goggles
• Nozzle Cleaning Kit
• Owner’s Manual
• Engine Manual
• Spray Gun
• Nozzle Extension
If any of the above parts are missing or damaged, call
the pressure washer helpline at 1–800–270–1408.
PREPARING THE PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged,
call the Pressure Washer Helpline at 1-800-270-1408.
To prepare your pressure washer for operation you
will need to perform these tasks:
• Unfold the handle and attach the wire form that
holds high pressure hose and spray gun.
• Connect the high pressure hose to the spray gun
and the pump and connect the water supply to the
pump.
• Add oil to the engine crankcase.
• Add fuel to the fuel tank.
Secure Handle and Wire Form
• Lift the handle upward and allow the locking caps to
slide over the bottom part of the handle to secure it
in place. (Figure 1).
• Insert the wire form into the handle with the longer arm
positioned on the left. From this view the hook should
resemble a “J” (Figure 2).
Add Engine Oil
IMPORTANT: Any attempt to crank or start the
engine before it has been properly serviced with the
recommended oil may result in an engine failure.
Generac 1800PSI High Pressure Washer
A A
S SS SE EM MB BL L
Y Y
GENER
A
C
Figure 1 — Lift the handle into an upright
position.
Lift the handle
to an upright
position and
slide the
locking caps
into place
Figure 2 — Fit wire form on handle.