Generac Power Systems 1042-1, Руководство пользователя

Страница: 7 / 24

Generac 2250PSI High Pressure Washer
GENER
A
C
A A
S SS SE EM MB BL L
Y Y
7
H i g h P r e s s u r e W a s h e r
The manufacturer recommends fresh, clean unleaded
automotive gasoline with a minimum of 85 octane.
• Use clean fuel and store in approved, clean, cov-
ered containers. Use clean fill funnels. Never use
“stale” gasoline left over from last season or gaso-
line stored for long periods (over 30 days).
• Clean area around fuel fill cap, remove cap.
(Figure 5).
• Add “UNLEADED” regular gasoline, slowly, to fuel
tank. Use a funnel to prevent spillage.
• Install fuel cap and wipe up any spilled gasoline.
Note: Some fuels, called oxygenated or reformulated
gasolines, are gasoline blended with alcohols or
ethers. Excessive amounts of these blends can
damage the fuel system or cause performance prob-
lems. If any undesirable operating systems occur, use
gasoline with a lower percentage of alcohol or ether.
Connect Hose and Water
Supply to Pump
IMPORTANT: You must assemble spray gun and
attach all hoses before you start engine. Starting
engine without all hoses connected and water sup-
plied will damage pump.
• Uncoil high pressure hose and attach one end of
hose to the base of the spray gun (Figure 6).
Tighten by hand.
• Attach other end of high pressure hose to the high
pressure outlet on the pump (Figure 7). Tighten by
hand.
• Before you connect your garden hose to the water
inlet, inspect the Inlet Screen (see Figure 8). Clean
the screen if it contains debris or have it replaced if
damaged. Do not run the pressure washer if the
inlet screen is damaged.
• Connect garden hose to water inlet. Tighten by
hand (Figure 8).
Figure 7 — Connect high pressure hose to
pump.
Figure 6 — Connect high pressure hose
to spray gun.
Figure 5 — Add gasoline to fuel tank.
Gas Cap
Connect High Pressure
Hose Here
Connect High
Pressure Hose
Here