Generac Portable Products 2,400 PSI High Pressure Washer
5
IMPORTANT: Read entire owner’s manual before you
attempt to assemble or operate your new pressure washer.
REMOVE PRESSURE
WASHER FROM
CARTON
• Remove the parts box included with pressure washer.
• Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat, then
remove all packing material.
• Roll pressure washer out of carton.
Carton Contents
Items in the carton include:
•
Main Unit
•
Parts Box (which includes the following):
•
High Pressure Hose
•
Wireform
•
Goggles
•
Nozzle Cleaning Kit
•
Owner’s Manual
•
Engine Manual
•
Owner’s Registration Card
•
Handle
•
2 Carriage Bolts
•
2 Knobs
•
Spray Gun
•
Nozzle Extension with Adjustable Nozzle
•
Oil Bottle
•
O-Ring Maintenance Kit
If any of the above parts are missing or damaged, call the
pressure washer helpline at 1–800–270–1408.
Preparing Pressure Washer for Use
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer helpline at 1-800-270-1408.
To prepare your pressure washer for operation, you
will need to perform these tasks:
• Add oil to the engine crankcase.
• Add fuel to the fuel tank.
• Attach the handle and attach the wire form that holds
the high pressure hose and spray gun.
• Connect the high pressure hose to the spray gun and the
pump.
• Connect the water supply to the pump.
Attach Handle and Wireform
• Place the handle onto the handle supports already
connected to the main unit. Make sure the holes in the
handle align with the holes on the handle supports.
(Figure 1)
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
• Insert the carriage bolts through the holes on the handle
and attach the plastic knobs. Tighten the knobs by hand
(Figure 2).
Make sure the
holes on the
handle are
aligned with the
holes on the
handle supports
Handle
Handle
Supports
Figure 1 — Attach the Handle to the Base
