Generac Portable Products 1421-1, Руководство пользователя

Страница: 8 / 24

Generac Portable Products 4,000 PSI High Pressure Washer
8
CHECKLIST BEFORE
STARTING ENGINE
Review the unit’s assembly to ensure you have
performed all of the following.
• Replace pump shipping cap with oil dipstick.
• Check for properly attached hose connections (high
pressure and water supply). Also, check to make
sure that there are no kinks, cuts, or damage to the
high pressure hose.
• Check that oil has been added to the proper level in
the engine crankcase before trying to start the
pressure washer.
• Add the proper gasoline to fuel tank.
• Provide a proper water supply (not to exceed 140°F)
able to supply a flow rate of at least 4.2 gallons per
minute.
• Be sure to read the “Safety Rules” and “Operation”
sections before using the pressure washer.
HOW TO USE YOUR
PRESSURE WASHER
If you have any problems operating your pressure
washer, please call the pressure washer helpline at
1-800-270-1408 .
How to Start Your Engine
The best way to start your engine–powered pressure
washer for the first time is to follow these instructions
step–by–step. This starting information also applies
whenever you start the engine after you have let the
pressure washer sit idle for at least a day.
• Place the pressure washer in an area close enough
to an outside water source that can provide a flow of
at least of 4.2 gallons per minute.
• Make sure the unit is in a level position.
• Check that the high pressure hose is properly
attached to the spray gun and to the pump. See
“Preparing Pressure Washer for Use”.
• Connect the garden hose to the water inlet on the
pressure washer pump and turn on the water.
WARNING!
Do Not run the pump without the
water supply connected and turned on. You
must follow this caution or the pump will be
damaged.
• Squeeze the trigger on the spray gun (make sure
the nozzle is in low pressure mode) to relieve the air
pressure caused by turning ON the water. Water will
discharge from the spray gun in a thin stream. Hold
the trigger until a steady stream of water appears.
This will make it easier to pull start the engine.
Release the trigger.
Figure 7 — Connect Nozzle Extension to Spray Gun