Generac Mobile MDE570P, Руководство пользователя, Страница: 41 / 80

Owner’s Manual for Mobile Generator 37
Figure 3-16. Emergency Stop Switch
Using the emergency stop switch overrides normal
shutdown sequence and bypasses the engine cool-down
period.
IMPORTANT NOTE: Using the emergency stop
switch for regular shutdown can result in equipment
damage.
Activate the emergency stop switch by pushing the
button in until it locks down. This trips the main circuit
breaker which then opens the contact, disconnecting the
load to the connection and ultimately shuts down the
engine. The emergency stop fault will be displayed on the
control panel. The switch will remain closed until it is
pulled out. The emergency stop should only be used in
emergency situations and not be used to shutdown the
generator during normal operation. Using the emergency
stop switch overrides normal shutdown sequence.
Towing the Unit
NOTE: Before towing the unit, see Trailer Hazards and
Towing Safety .
Hitch and Coupling Guidelines
•
Verify the hitch and coupling on the towing vehicle
are rated equal to, or greater than, the trailer's
Gross Vehicle Weight Rating (GVWR).
•
Verify the trailer hitch and the coupling are
compatible. Verify the coupling is securely fastened
to the vehicle.
•
DO NOT tow trailer using defective parts. Inspect
the hitch and coupling for wear or damage.
•
Connect safety chains in a crossing pattern under
the tongue.
•
Before towing the trailer, verify the weight of the
trailer is equal across all tires. On trailers with
adjustable height hitches, adjust the angle of the
trailer tongue to keep the trailer as level as
possible.
Preparing Unit for Towing
1.
Verify engine is OFF.
2.
Use the tongue jack to raise or lower the trailer
onto the hitch of the towing vehicle. Lock the hitch
coupling and attach the safety chains or cables to
the vehicle. Raise the tongue jack to the highest
positions providing the maximum clearance
between the ground and the jack.
NOTE: Maintain a film of grease on the coupler to extend
coupler life and eliminate squeaking. Before towing, wipe
the coupler clean and apply fresh grease.
3.
Lubricate grease fittings on leveling jacks to ensure
proper operation of the jacks. See
Jack Mainte -
nance .
For maintenance interval information, see
Basic Maintenance Schedule .
4.
Connect trailer wiring harness to tow vehicle. Verify
proper operation of directional and brake lights.
5.
Verify all doors and hoods are properly latched.
6.
Verify all tires are inflated to the correct pressure.
See Specifications .
7.
Check all wheel lugs. Tighten or replace any loose
or missing lugs. If a tire was removed for axle ser -
vice or replaced, tighten lugs in the order shown in
Figure 3-17
to the following specifications:
Figure 3-17. Lug Sequence
8.
Verify all axle oil baths have adequate levels for
towing.
EME
RGENCY
STO
P
014021
a. Start all lug nuts by hand.
b. First pass tighten to 50–60 ft-lb (67–81 Nm).
c. Second pass tighten to 150–200 ft-lb (203–271
Nm).
d. Third pass tighten to 275–325 ft-lb (373–441 Nm).
1
3
4
5
6
7
8
2
001441
WARNING
Property or Equipment Damage. Tighten wheel lug
nuts after first 50 miles to factory specifications.
Failure to do so could result in death, serious injury,
property or equipment damage.
(000235)