Genelec GLM 4, Быстрая настройка

Страница: 13 / 28

13
To calibrate a monitoring group
1. Check the serial number of the measurement micro-
phone (measurement microphone calibration file is
retrieved during first calibration)
2. Select the calibration mode; either a single location
measurement (SinglePoint) or measurements of
multiple measurement positions (MultiPoint). Select
the Symmetrical EQ if a Left/Right pair of monitors
should receive the same calibration filters. The
Individual EQ would be useful for unsymmetrical
setups where one monitor is in a corner and the other
free-standing. In order for the symmetric filters func
tion to be used, monitors need to be symmetrical on
the grid. Monitor pairs not positioned symmetrically
on the grid will be handled as individual units.
3. Connect the measurement microphone to the GLM
network adapter, place the microphone at the listen
ing position, at ear height, and click on the ‘Start
Calibration’ button to start the measurement and
follow the dialog instructions.
- All monitors and subwoofers will be measured,
and if MultiPoint is selected then next position(s)
will be measured.
- Optimization starts.
- Wait until optimization finishes.
- The calibration results can be viewed by clicking
any loudspeaker icon.
4. Click ‘Confirm Calibration’ button to accept and save
the settings to the setup file.
If there is a subwoofer in the group, the next step of
the process is the automatic adjustment of the phase
(AutoPhase).