Genelec 7382A, Руководство по эксплуатации

Страница: 3 / 12

Table 1. Recommended cable gauges for
different lengths of signal cable.
in large immersive installations with bass
management of surround channels, one
9301A is required per 7382A.
Analog Output 1 and 2
Analog balanced XLR connectors connect
the subwoofer to the monitors.
These analog outputs carry an unfiltered
copy of the inputs. The subwoofer/main
monitor crossover is adjusted in the GLM
software from 50 Hz to 100 Hz in 5 Hz
increments.
See chapter "Bass Management" for
details.
THRU AES/EBU
The THRU AES/EBU is a bit-to-bit copy of
the digital audio signal on the IN Digital. This
output can be used for digital sharing of the
audio between subwoofers in the case where
multiple subwoofers are used. This output
can also be used for distributing a stereo
digital audio signal to monitors, creating a
2.1 digital audio stereo monitoring system.
Subwoofer Connector
This Speakon connector is used for
linking the RAM-SW amplifier unit and the
7382A subwoofer enclosure. There is a
corresponding connector on the reflex port
end of the enclosure.
Figure 1. Connector panel of the RAM-SW amplifier unit.
Cable Gauge Max. Length
4 x 2.0 mm 2 (14 AWG) 30 m / 100 ft
4 x 2.5 mm 2 (13 AWG) 40 m / 130 ft
4 x 3.3 mm
2
(12 AWG) 50 m / 165 ft
4 x 4.0 mm 2 (11 AWG) 60 m / 200 ft
SUBWOOFER
CONNECTOR
CONNECT ONLY TO GENELEC NETWORK
CONTROL NETWORK
MAINS INPUT
50 / 60 Hz 1100 W
100 - 120 V~
220 - 230 V~
LFE IN IN THRU
SERIAL NUMBER
RAM-SW AMPLIFIER
MODULE
www.genelec.com
MADE IN FINLAND
LED CONNECTOR
This device complies
with FCC Part 15 and
Canadian ICES-003
radio frequency Class
A emission
requirements. Refer
to operating manual
for full information.
2 1 3 OUT / THRU
IN
1
1
2 3
3
2
-
GND
+
IN 1 OUT 1 IN 2 OUT 2
ELECTRIC SHOCK HAZARD. DO NOT OPEN. DO NOT
SUBJECT TO WATER OR MOISTURE. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED
PERSONNEL. USE EARTHED MAINS CONNECTION ONLY.
WARNING
RISQUE DE CHOC ÉLECTRIQUE. NE PAS OUVRIR. NE PAS
EXPOSER À L'EAU OU L'HUMIDITÉ. AUCUN COMPOSANT À
L'INTÉRIEUR REMPLAÇABLE PAR L'UTILISATEUR. ADRESSER
TOUTE RÉPARATION À UN PERSONNEL QUALIFIÉ. CET
APPAREIL DOIT ÊTRE RACCORDÉ À LA TERRE.
AVERTISSEMENT
LAITE ON LIITETTÄVÄ SUOJAKOSKETTIMILLA VARUSTETTUUN
PISTORASIAAN. APPARATET MÅ TILKOPLES JORDET
STIKKONTAKT. APPARATEN SKALL ANSLUTAS TILL JORDAT
UTTAG.
THIS AMPLIFIER HAS BEEN CALIBRATED FOR USE WITH THE
LOUDSPEAKER MARKED WITH THE SAME SERIAL NUMBER.
DO NOT MIX THE CALIBRATED AMPLIFIER/LOUDSPEAKER
PAIRS ! TURN OFF POWER BEFORE DISCONNECTING
LOUDSPEAKER CONNECTIONS !
NOTE !
DIGITAL AES/EBU
ANALOG
ANALOG LFE
CHANNEL
INPUT
ANALOG SIGNAL INPUTS
AND OUTPUTS 1 AND 2
DIGITAL AES/EBU
IN AND THRU
CONNECTORS GLM CONTROL
NETWORK
CONNECTORS
REMOTE LED
CONNECTOR
SUBWOOFER
CONNECTOR MAINS
CONNECTOR
Figure 2. GLM Network cabling. Audio cabling not shown.
LISTENING
POSITION
MICROPHONE
GLM
NETWORK
GLM
NETWORK
GLM
NETWORK
USB
RAM-SW
RAM-XL RAM-XL
Max. Room
volume
m 3 (ft 3 )
Front monitors
Stereo & LCR
Subwoofers for
2-channel Stereo
Subwoofers for
>5-channel Immersive
125 (4400) S360 2x 7380 (1) 3x 7380 or 1x 7382 (1)
125 (4400) 1237 2x 7380 (1) 3x 7380 or 1x 7382 (1)
125 (4400) 1238DF 2x 7380 (1) 3x 7380 or 1x 7382 (1)
170 (6000) 1238 / AC 3x 7380 or 7382 (1) 1-2x 7382 (1)
200 (7000) 1234 / AC 7382 (1) 2x 7382 (1)
400 (14000) 1236 2x 7382 (2) 2-3x 7382 (2)
1) Additional subwoofers of the same type may be required in a larger room with bass heavy program
material.
2) Subwoofers are not necessarily required for a 1236A installation as these monitors are already full
range. For immersive systems, subwoofers can be used to reproduce the LFE channel.
Table 2. Recommended subwoofer/main monitor combinations.