17
automatically when the time is up.) The video file is AVI format.
C. Set the Frame Rate
Click [Capture] -> [Set Frame Rate], and click open “Choose Frame Rate” to
set the frame rate.
D. Set Time Limit
Click [Capture] -> [Set Time Limit] to set the time limit while capturing video.
E. Note:
Do not connect / disconnect the USB cable when the application is running,
which will cause the program to be interrupted.
CONTROLLING VISUALIZER BY COMPUTER
You can control the visualizer from a computer connected with a RS232
connector.
A. Connect the computer and the visualizer using the RS232 cable.
B. Double click X:\ 232 Control\Control Panel (you can open this file from the
CD and double click it, or copy this file to any directory on your computer’s
hard drive and double click to launch it).
CONTROLLING PROJECTOR BY VISUALIZER
The code writing software is used to inputting projector’s control code, then
can control various projector with the visualizer.
1. Connect the visualizer to the projector with the RGB
ǃ
VIDEO
ǃ
S-VIDEO
cables.
2. Connect the RS232 cable to the computer’s connector. The visualizer’s
RS232 port is located on its right side.
3. After completion of the connection, turn on the visualizer
ˈ
click [start] -> [All
Programs] -> Visualizer ->
and the following dialog box
18
appears as below:
When the indicator of “Current RS-232 Connection Status” is green, that
means the connection between the visualizer and the computer’s RS232
connector is good. If the indicator is red, please check if the RS232 cable is
connected correctly. When all the cables are connected correctly, please click
“Projector” to select your projector model under the drop-down list, then click
“Send”. If you can not find your particular projector model in the “Projector”,
please do the following:
1)
ˊ
Select “Baud rate” and “parity” and input the projector control code. (The
baud rate, parity and control code is supplied by projector’s manufacturer,
please refer to the projector’ manual)
The input format of projector’s control code is as follows:
a. If the data is in the numerical value format, please input data directly, block
them off with comma, do not distinguish lowercase and uppercase.