LRAD
450XL
GENASYS INC.
Manual Part No.: 112343-00 Rev. E
19
Status:
The Control Module status will display one of the following:
PLAY – The selected audio file is under playback and should be heard through the LRAD
depending on the LRAD’s volume setting.
PAUSE – The selected file is paused and will resume playback when the PLAY/PAUSE button is
pressed from the point in the file at which it was paused.
STOP – The selected file is stopped and will resume playback when the PLAY/PAUSE button is
pressed from the beginning of the file.
ALERT – The LRAD Alert tone is being played and should be heard through the LRAD depending
on the LRAD’s volume setting.
ERROR – The Control Module’s onboard memory is not formatted.
File Type:
The display will read “MP3”, “WAV” or “WMA”, depending on the recording format
of the digital media file selected.
Repeat Mode:
The character “R” will be displayed here if the Control Module is in repeat mode.
In repeat mode, the selected file will play to the end and then automatically play again from the
beginning in a continuous fashion until the STOP button is pressed or until the player is taken
out of repeat mode and the file plays to completion.
Time Elapsed:
Displays the current playback time of the selected file. This counter resets when
the file restarts in repeat mode.
Audio File Name:
Displays the file name of the audio file selected. If the file name is too long to
fit in the width of the display, the file name will continuously scroll right to left.
Upon first powering up, the Control Module will display a splash screen indicating the current
firmware version. To check the current firmware version, cycle the connection between the
Control Module and the LRAD and make a note of the splash screen.
Figure 16: Control Module Splash Screen
