3
SSWW
Fail u r e s o l ution
8
、Bubble
bath function(air pump )
+
-
Press
0
3
Key of the panel or remote panel, open disinfection function for 15 minutes, the
LCD screen shows icon and remain time, press the Key again to close disinfection.
When the system is open and water is full, press the panel or remote panel Key once to
open air pump. The LCD screen shows air pump icon as follow figure. Press Key on panel
or remote panel by the second time to close the air pump. Under the state of air pump
opening, if system changes from full water to lack water, or opening it when lack of water,
the air pump will stop after 15 minutes.
Activated thermostat, the LCD screen's temperature icon brightened, and press this Key
again to close thermostat. When the bathtub temperature is below the set temperature, the
thermostat and heating rods is activated, when the bathtub temperature reached setting
temperature, thermostat stop heating rods (if being lack of water, thermostat cannot be
started, and it will be shut down automatically if working). Two seconds before the start,
when the temperature icon shining, under thermostat press FUN Key of panel or remote
panel third time, then press the or Key of panel or remote panel can be set thermostat
of the water tank. System default temperature is 35
°
C. Adjustable range is 15-45
°
C.
9
、
Di sinfection.
Problem
Possible reason
Solution
The water level has not
reached the probe
Continue adding water,let
the water level reach
the probe
Air driven switch faulty
Replace
Loose plug
Fix the plug
Pump jammed with rubbish
Clear the blockage
Pump cannot start
Pump is damaged
Replace
Failure of adjuster
Replace the sealing rubber
ring inside
Massage failure
Air pipe leakage or loose
connection
Clearing the blockage
tighten the connection
Join rings broken
Replace
Lock nut may be loose
Tighten the nut
Leakage
Adhesive glue aging
Use new adhesive glue
Ground bolt is loose or free Adjust ground bolt to touch
the ground
Shaking is too
Severe
Backwater is jammed
Clear the rubbish in
Strainer
Lamp circuit is not closed
Fix the lamp circuit
Bulb is damaged
Replace
Pump runs but the
lamp is not working
Transformer is damaged
Replace
P age 9
http
://
www
.
gemy
.
cn
