3
7. Insert the tether stakes into the ground and attach the tethers(See illustration 4).
8. To deflate, unplug fan. For faster deflation, unzip zipper after unplugging fan.
Do not unplug by pulling on cord.
USER SERVICING INSTRUCTIONS
Lamp Replacement
Disconnect the plug from the electrical outlet and allow the lamp to cool completely before replacing bulb. Do not touch
the bulb when the power is "ON" as it is extremely hot and make cause electrocution.
1. Grasp plug and remove from receptacle or other outlet device. Do not unplug by pulling on the cord.
2. Open the zipper opening on the Airblown
®
Inflatable.
3. Open the protective light cover carefully by pressing down on the two locking side tabs simultaneously.
4. Replace lamp with same type 7W maximum, candelabra base, UL classified.
5. Do not over-tighten the lamp as this may damage the lamp or lamp holder.
Replace only with same type C7, 7 Watt Max Candelabra-base 120 Volt UL Classified lamps.
CAUTION
Fuse Replacement
WARNING:
Risk of Fire:
Replace only with same size and type of fuse.
WARNING:
Risk of Fire:
Do not replace the attachment plug. Contains a safety
device (fuse) that should not be removed. Discard product if attachment
plug is damaged.
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling
on the cord.
2. Open fuse cover. Slide open the fuse access cover on top of the attachment plug towards
blades. (See illustration)
3. Remove fuse carefully.
4. Replace fuse only with 5 Amp Max, 125 Volt (provided with product).
5. Close the fuse cover. Slide closed the fuse access cover on top of the attachment plug.
CAUTION
To reduce the risk of fire do not deliberately reposition either lamp holder contact.
Do not attempt to inflate your Airblown
®
Inflatable during unusually strong winds. If it becomes too windy for safe
operation, simply allow your Airblown
®
Inflatable to deflate and wait for better conditions before re-inflating.
Protect the electric fan and power cord from direct exposure to water. This precaution will reduce the risk of electrical
shock. When the temperature is below 14° F (-10° C), the motor may temporarily stop running. The motor will begin
functioning again higher temperatures.
WARNING
Remove all plastic fasteners and tags. These are part of the packaging and should be discarded.
This item is not a toy and should be used for decorative purposes only.
For indoor and outdoor use.
120 V 60 Hz.
TROUBLE SHOOTING CHECKLIST
If your Airblown
®
Inflatable is not inflating, the problem may be:
illustration 4
