INSALLER MANUAL - PAGE 07
PAGE 06 - INSALLER MANUAL
1
1
4
3
km/h
+12V
5
MUTE
6.0 - CONNECTIONS
Check the length of the cables before proceeding with the final positioning of the
accessories.
For the system to activate every time reverse is engaged, connect the
BLACK-YELLOW wire to the reverse gear positive wire, set speed signal pulses to 1
(par. 8, parameter 11) and increase deactivation delay to more than 10 seconds (par. 8,
parameter 12).
For system operation see paragraph 3.3.
!
!
!
!
!
!
!
!
!
Position the control unit (4) under the driver dash, in a dry place, away from eventual water
infiltrations and heat sources.
Run the cables along the front bumper and route them inside the vehicle cabin.
Fix the buzzer (3) inside the vehicle cabin where you can hear the warning signal. Make sure you
install it in a dry spot, away from eventual water infiltrations and heat sources.
Fix the LED push-button (20) where it can be easily reached.
Connect the BLACK-BLUE wire of the main control unit (4) to the positive under key of the vehicle.
Connect the BROWN wire to the metal frame of the vehicle.
(Optional) connect the BLACK-YELLOW wire to the o
of the vehicle (see chapter
“setting of parameters”
).
dometer signal
for the programming of the pulses
!
!
!
!
Plug the buzzer terminals with the YELLOW and BLUE wires to the main control unit wiring harness
connector (5), respectively in positions 15 and 3.
Plug the LED push-button terminals with the RED, WHITE and BLACK wires to the main control
unit wiring harness connector (5), respectively in positions 18, 19 and 7.
(Optional) connect the GREY-RED wire for the “mute” feature to the corresponding wire of the car
radio preset for this feature.
Plug the 24-way connector of the main control unit wiring harness (5) into the corresponding
connector of the main control unit (4).
Clean thoroughly the plastic brackets (6 or 6a) and around the holes, apply
“PRIMER” (12), let dry for at least one minute and then proceed as follows.
!
12
6 6a
7
PRIMER
3M
4298UV
10
NO
YES
+18°C
Remove the protective film from the adhesive (7) and apply it to the bracket (6 or 6a) or snap the
bracket (8) in the hole from the outer part of the bumper.
.
In both cases position the plastic brackets so that the connector of the sensor comes out
horizontally
