9.0 - PAIRING NEW DEVICES
9.2 - Without BROWN/GREEN wire ground connection
!
!
!
!
!
T
or
sensor
)
A Bop and
turn
will confirm the end of the
procedure.
To pair a new device, proceed as follows:
Arm and then disarm the alarm via remote control or override key.
urn ignition key to ON
The status LED will turn ON for 1 sec.;
While the LED is ON, simultaneously press both buttons on the remote
control or touch the override key to its receptacle.
Two flashes of the turn indicators, a Beep and a Bop will confirm the
system is in learn mode.
Depending on which device is to be paired either press one of the remote
control buttons OR touch the override key to its receptacle OR make the
magnetic contact transmit (bring contact and magnet together and then
move apart) OR press the button on the opening detector, make the
infrared sensor
transmit (refer to
sensor instructions .
If another device needs to be paired, wait 2 sec. before doing so.
To exit learn mode , turn ignition key OFF.
a flash of the
indicators
.
Make sure passive arming is disabled.
!
!
!
!
!
wireless hyper-frequency
PAGE12
PAGE13
9.1 - With BROWN/GREEN wire ground connection
The alarm is supplied with 2 remote controls and 1 override key but other
optional devices can be added.
CAUTION
Alarm memory will only store 8 devices.
Saving an extra device will automatically delete the first one.
To pair a new device, proceed as follows:
Arm and then disarm the alarm via remote control or override key.
Lift the seat or open the topcase or, if there is no contact switch, ground the
BROWN-GREEN wire.
Connect the WHITE-VIOLET wire to ground.
Turn ignition key to ON.
Two flashes of the turn indicators, a Beep and a Bop will confirm the system
is in learn mode.
Remove the WHITE-VIOLET wire from ground.
Depending on which device is to be paired either press one of the remote
control buttons OR touch the override key to its receptacle OR make the
magnetic contact transmit (bring contact and magnet together and then
move apart) OR press the button on the opening detector, make the infrared
sensor
transmit (refer to sensor
instructions .
A flash of the turn indicators and a Beep will
To pair another device, ground the WHITE-VIOLET wire for 1 sec.
To exit learn mode, turn ignition key OFF.
a flash of the
indicators
Close the seat/topcase or remove the BROWN/GREEN wire from ground.
!
!
!
!
!
!
!
!
!
!
!
!
!
Make sure passive arming is disabled.
or
sensor
)
confirm the operation has been
completed successfully.
A Bop and
turn
will confirm the end of the procedure.
wireless hyper-frequency
