RAC10 Small SpaceCooling
®
Effective room airfl ow control and monitoring solution for servers,
network switches and phone systems in small spaces.
10001901
The RAC10 system evacuates heat load from the small space and sends it to the outside corridor or ceiling plenum return.
Maintain a perfectly controlled environment for your small computer and network rooms using building air while providing the
needed visibility to cooling capacity and environment information and alarms. Email alerts and the web interface provides remote
alarms and management for superior visibility and control of the room environment.
• Continually deliver cool air to your IT equipment.
• Real-time plus historical cooling capacity and environment monitoring.
• Early alarm notifi cation to email account/s through a secure Ethernet connection.
• Allow multiple email or SNMP trap recipients with escalation.
• Quickly deploy into ceiling or attach to wall in minutes. Web browse to device, set-up
email and/or communicate with existing management software.
Wall Mount
Ceiling Mount
• With RAC10 unit installed and temperature sensors located at air
entry to space and IT equipment air intake vent, connect to AC
power using attached 10FT cord.
• During start-up the RAC10 system will perform a self check.
• Access the web interface using the supplied default web address.
• Adjust factory default settings as desired.
• Refer to the User Manual for details.
Ceiling Mount
To install the RAC10 in a drop ceiling, 16 gauge hanger wire must be
used to support the unit. Attach the hanger wires to the four eyelets
on the backside of the RAC10. Place the RAC10 across the ceiling
grid using the hanger wire to support the weight. Plug the RAC10
into the power receptacle which is required to be out of the ceiling
plenum. Option Duct Kit can be ordered if required.
Wall Mount
The dimensions of the RAC10 fan enclosure is 14 1/4” x 21 1/4”.
The RAC10 fi ts between the standard 16” center studs. Mounting as
close the ceiling will maximize the heat exhausted. Use 2”, #10 wood
screws to attach the unit to the wood studs. A power receptacle is
required within close proximity to the RAC10.
Thermal Control & Monitoring Software
System Start-up
id
id
ili
l
