9
www.geiger.de
EN
EN
10. Learning / deleting the transmitters
Activate the learning mode (only necessary for further handheld
transmitters):
Connect the motor to the power supply.
Switch on the mains.
The motor makes a short back and forth movement
(1 x “click-click“). In the near range press UP or DOWN key
and keep it pressed for about 3 seconds until the motor
confirms (1 x “click–click“).
After each interruption of the voltage supply, the learning mode
can
be activated for 30 min.
The learning mode is necessary in order to transmit transmitters or in order to be
able to adjust the end positions again.
I
The learning mode must be activated
first in order to learn / delete the trans
-
mitters.
I
If no action takes place within
60 seconds, the learning mode is
deactivated. The motor returns to normal
operation (3 x “click-click“).
In the close range press UP or DOWN key for about
1 second. The motor confirms (1 x “click-click “).
The transmitter is taught to the motor.
Deleting the transmitters
I
The learning mode must be activated
first in order to learn / delete the trans
-
mitters.
At close range, press the UP or DOWN key for about
5 seconds. The motor reacts immediately (1 x “click-click”).
Keep the key pressed about 5 sec. until the motor confirms
the deleting of the transmitters with 1 x “click-click”.
I
Please note: You can only delete all transmitters and sensor trans-
mitters together. It is not possible to delete individual transmitters.
230
V
On
Off
connect to
mains
1 x “click-click“
max. 15 cm
click-
click
or
approx 1 sec.
1 x
max. 15 cm
click-
click
or
approx 5 sec.
1 x
