GEIGER GF20 Series, Оригинальная инструкция по сборке и эксплуатации

Страница: 4 / 8

4
Gerhard Geiger GmbH & Co. KG | 100W0689 1218 V000 en
EN
EN
8. Programming the sun automatic function to a Geiger motor
or an external radio receiver
I
The operation is to be performed during the 30 minutes after the
power supply has been switched on.
1. Select the sun automatic channel ( ) with the channel
selection keys ( ).
2. In the near range press the UP ( ) or DOWN ( ) key
for about 3 seconds until the motor confirms with an
audible signal (1x click-click).
3. Hold the handheld transmitter to the power cable and
press the UP ( ) or DOWN ( ) key for 1 second. The
motor confirms with an audible signal (1x click-click).
Then program the handheld transmitter in the Geiger
sun/wind sensor.
4. Hold the bottom side of the handheld transmitter on
the left side of the sun/wind sensor, press the UP or
DOWN key – the sun icon of the handheld transmitter
lights up – until the red LED of the sun/wind sensor
lights up.
9. Sun automatic
To enable / disable the automatic sun function, press the channel selection keys ( ) until the
sun icon ( ) lights up.
The sun automatic function is activated with the UP key ( ) and deactivated with the DOWN
key ( ).
230
V
On
Off
connect to
mains
1 x “click-click“
max. 15 cm
click-
click
1 2 3 4 5 6
or
about 3 sec.
1 x
max. 15 cm
click-
click
1 2 3 4 5 6
or
about 1 sec.
1 x
12345
6
12345
6