Gehl SL3640E, Руководство оператора, Страница: 38 / 88

34 917334/BP0310
Changing Attachments
To prevent unexpected attachment release
from the attachment bracket, be sure to prop-
erly secure the latch pins by rotating the latch levers to a horizontal
position.
The skid-steer loader features a All-Tach™ attaching mechanism for mounting a
bucket or other attachment. Two latch levers secure the attachment.
Connecting an Attachment
1. Rotate the latch levers to a vertical
position to fully retract the latch pins.
2. Start the loader engine and make sure
the lift arm is lowered and in contact
with the loader frame.
3. Align the loader squarely with the
back of the attachment.
4. Tilt the attachment bracket forward
until the top edge of the bracket is
below the flange on the back side of
the attachment and centered between
the vertical plates.
5. Slowly drive the loader forward and, at the same time, tilt the attachment
bracket back to engage the flange on the back side of the attachment.
6. Stop forward travel when the flange is engaged, but continue to tilt the attach-
ment bracket back to lift the attachment off the ground.
7. Exercise the MANDATORY SAFETY SHUTDOWN PROCEDURE
(page 6).
8. With the loader engine OFF, leave the operator’s compartment and rotate the
latch levers to a horizontal position to fully engage the latch pins.
Important: To check that the attachment is properly installed, apply down pres-
sure to the attachment prior to operating.
Connecting Auxiliary Hydraulic Couplings
Note: With the engine OFF, key in the ON position and the restraint bar down,
the auxiliary hydraulic control can be moved to relieve any pressure in the
hydraulic system.
The hydraulic couplers are located on the left lift arm. “A” port is pressure, “B”
port is return when the auxiliary control is in the detent position.
WARNING
Figure 15 Hitch – disengaged
1. Latch Levers
2. Latch Pins
1
1
2 2