Gehl R135, Руководство оператора

Страница: 100 / 206

96 50940193/DP0415
Changing Attachments
To prevent unexpected release of the attachment
from the hitch, make sure the attachment is fully
locked onto the hitch before using the attachment. On manual All-Tach®
hitches, rotate the latch levers fully. On Power-A-Tach® hitches, verify
that the pin flags are all the way to the outside of the hitch.
Always verify that the locking pins on the hitch are fully engaged down
through the holes in the attachment frame before using the attachment.
The attachment could fall off if it is not locked on the hitch and could
cause serious injury or death.
Connecting Attachments
1. In an open, level area, place the
attachment lock into the unlocked position
(Figure 61):
• All-Tach® system manual hitch:
Move hitch lock lever (G) all the way
to the right.
• Power-A-Tach® system quick attach
hitch: Press the Power-A-Tach® sys-
tem unlock button (I) on the control
keypad until safety flags (H) have
moved all the way in.
2. Tilt the attachment plate forward and drive
the machine straight forward toward the
back of the attachment
3. Lower the lift arm so tabs (J) on the top of
the attachment plate are aligned just under
the hooks on the back of the attachment.
4. Tilt the attachment plate back until tabs (J)
on the top of the attachment plate are
engaged against the hooks on the back of
the attachment.
5. Raise the lift arm slightly until the
attachment is hanging from the hooks on
the back of the attachment and tabs (J) are
firmly inserted into the hooks. Tilt the
attachment plate back, if necessary, so the back of the attachment is resting flat against
the attachment plate.
WARNING
Manual Attachment Hitch In
Unlocked Condition
Power-A-Tach® System Quick
Attach Hitch In Unlocked Condi-
tion
Figure 61 – Attachment Hitch
Unlocked
G
I
H
J
J
J
J