IR REMOTE CONFIGURATION
11
1 2
1 2
1 2
1 2
Remote Channel 3:
Remote Channel 1:
Default
Remote Channel 2:
Remote Channel 4:
The IR channel selected on the RMT-8MIR Remote must match the IR channel
assigned to the 4x2 Matrix for HDMI. For example, if both DIP switches on the
remote are set to the down position (IR channel 1), the 4x2 Matrix for HDMI must
also be set to IR channel 1.
See page 12 on how to change the IR channel on the 4x2 Matrix for HDMI.
Setting the IR Remote Channel on the RMT-8MIR
In the event that IR commands from other remote controls confl ict with the
supplied RMT-8MIR Remote, changing the remote IR channel will fi x this issue.
The RMT-8MIR Remote has a bank of DIP switches for setting the Remote IR
channel.
The DIP Switch bank on the RMT-8MIR is located underneath the battery cover.
Left:
Picture of the opened rear battery
compartment of the IR remote showing the
exposed DIP Switch bank between the battery
chambers. Above: all 4 possible combinations
of the DIP switches showing the possible
channel selections.
