Gefen EXT-HDMI1.3-CAT5-ELR, Руководство пользователя

Страница: 13 / 19

10
DIP SWITCH SETTINGS
DIP 1 - EDID Mode
ON (default) - External EDID Mode
• DDC and HPD are passed through. Both the connection status and the full
A/V capabilities of the display. The HPD status will also be detected by the
source device.
OFF - Internal EDID Mode
• Local EDID is used instead of the EDID from the display device. EDID
features newer than HDMI 1.3 are removed when the display is read. This
provides a general EDID which is compatible with more displays.
DIP 2 - Hot-Plug Detect
DIP switch 2 only works when DIP switch 1 is set to the OFF position.
ON - HPD Pass-Through
• HPD follows upstream HPD towards the source. The HPD signal will refl ect
the connection status between the display device and the source device. If
the source or display is temporarily disconnected then reconnected, there
will be a delay of 20 - 30 seconds before the A/V content is restored to the
display.
OFF (default) - HPD Always High
• The HPD signal remains high regardless of the downstream HPD state. If
the source or display device does not properly handle HPD (no picture after
connecting / reconnecting source or display), set this DIP switch to the OFF
position.
DIP 3 - Supports DVI Connections
ON
• Set DIP switch 3 to the ON position when using a DVI source or display.
HDCP content is
not supported in this mode.
OFF (default)
• If HDMI is connected, set DIP 3 in the OFF position.