Gefen EXT-DSC, Руководство пользователя

Страница: 9 / 37

6
How to Connect the Digital Signage Creator
1. Connect a HDMI and/or VGA compliant display device to the output port(s)
on the rear panel of the Digital Signage Creator. A single 6 foot HDMI cable
(male to male) is supplied.
2. Optionally, the user can connect an ampli fi ed speaker or audio device to the
3.5mm L/R analog stereo output for external audio support.
3. Optionally, the user can utilize the mini-plug to RS-232 serial
communications port to communicate with controllable RS-232 devices.
4. Connect the EXT-DSC to the local network using the Ethernet port on the
front panel of the unit. If using this as a stand-alone solution this step is not
necessary. As a standalone unit, uploading of media must be done manually
using the integrated USB port.
5. Connect the included 5V DC power supply to the power input receptacle.
Connect the plug-end into an open wall power socket.
Initial Bootup of the Digital Signage Creator
Upon the fi rst boot up of the DSC a series Gefen splash screen should be visible
on the connected display. This initial boot-up process should take approximately
1.5 minutes. Subsequent boot-ups after the initial boot process will be reduced
in time to ~50 seconds. Once the boot-up process is complete a default logo
animation should be seen.
If your system did not have the behavior described above you may have a
defective unit. Before contacting Gefen, make sure that the digital displays are
functional and that the right input has been selected (some displays have multiple
inputs and you may need to manually select the right one). Also check that the
push button is not pressed by external elements. If the set-up appears correct,
try to power down and up the EXT-DSC unit by unplugging and plugging in the
power again. If this does not correct the errors send a message describing what
you observe to support@Gefen.com
CONNECTING AND OPERATING THE DIGITAL SIGNAGE CREATOR