Gefen EXT-DP-4K600-1SC, Руководство пользователя, Страница: 16 / 22

page | 6
Installation
Connection Instructions
► Video
1. Connect the included DisplayPort cable between the DisplayPort 1.2 source and the
Input port on the Sender unit.
2. Connect a DisplayPort 1.2 display to the Output port on the Receiver unit, using the
included DisplayPort cable.
► Fiber
3. Connect a single SC-terminated OM3 or OM4 (50/125 μm) multimode fiber optic
cable, up to 660 feet (200 meters), between the Link port on the Sender unit and the
Link port on the Receiver unit.
► Power
4. Connect the included 5V DC power supplies to the 5V DC port on both the Sender
and Receiver unit.
5. Connect the opposite end of the power supplies to available electrical outlets.
6. The Link indicators on both units will light once all connections are complete and the
units, the source, and the display are powered up.
EQ Switch Configuration
Sender unit - By default, this switch is in the “Off” position. Set the switch to the “DE”
(signal de-emphasis) setting, if the source output is very high.
Receiver unit - By default, this switch is set to the “Off” position . Set to the “PE”
(signal pre-emphasis) position if the sink device requires a higher than normal input level.
Ge
tting S
tar
ted
Ge
tting S
tar
ted
®
4K 600 MHz
DisplayPort Extender
over one Fiber
Sender
Input Link
EQ
EXT-DP-4K600-1SC-TX
Off DE
Link
5V DC
®
4K 600 MHz
DisplayPort Extender
over one Fiber
Receiver
Output Link
EQ
EXT-DP-4K600-1SC-RX
Off PE
Link
5V DC